Water Cooler Cleaning Instructions

Special Instructions For Hot & Cold Units
Do not allow sanitizing solution to enter hot tank! You must plug up the hot tank hole with plumbers putty (found at your local hardware store) before cleaning proceeds.

Cleaning Instructions
1. Remove empty bottle
2. Unplug the cooler from the wall.
3. Drain out any water left in the reservoir
4. Let cooler stand for a few minutes to allow any ice in the reservoir to melt.
5. Fill reservoir 3/4 full of clean water and add 1/2 tablespoon of liquid clorox bleach in water.
DO NOT USE STRONGER SANITIZING SOLUTION
6. Allow water to stand for 5 minutes
7. Important. Drain water and sanitizing solution out of tank...through the cold spicket only.
8. Flush thoroughly!!! Fill and empty through spicket no less than 6,7 times.
9. If you experience a taste problem, place 1 tea spoon of baking soda into reservoir and add water. Allow to sit for 5 minutes and repeat flushing instructions.